Wollte heute mal den #nylockmod auf meinem #prusamk3s fertig machen. Dann hat der Spaß erst begonnen....ständig hat der Thermistor den low bed temp Fehler ausgelöst und den Drucker Not ausgeschalten🥵

Nach langer Fehlersuche hab ich den Stecker vom Thermistor als Fehlerquelle identifiziert...hatte die Hoffnung ein Tropfen Superkleber würde das Metall im Stecker besser befestigen und den Wackelkontakt beheben....

I finished printing all parts for the mask - and it was a very close finish regarding filament 😸

Now I gotta cut out and replace the eyes and do all the gluing, carving and painting.
I feel like this might look so cool 😻

#3dprinter #3dprint #3dprinting #prusa #prusamk3s #zelda #LegendOfZelda #Majora #MajorasMask

I got some new filament and finally finished my last big print.

Stop - benchy time 👯‍♀️

#3dprint #3dprinting #3dprinter #prusa #prusamk3s #benchy #benchy3d

OK, I finished half of my Majoras mask project, the other half is printing right now and will take until tomorrow late evening 😸
But even half of that mask looks creepy as hell and it's not even painted, yet.
I absolutely love it 😻

#3drinter #3dprint #3dprinting #prusa #prusa3d #prusamk3s #zelda #majora #majorasmask

My #Prusa #MK3S is stuck in a recalibration loop after several days of rain, and then several days of running a dehumidifier. Last time when this happened indoors, it was a lubrication issue. I had to clean the rails and then lubricate with a thin #RCCar lube.

Has anyone tried graphite lubricants that might be less dust and humidity sensitive?

#prusamk3s
#3DPrinting #3DPrinters
#Maker #Makers

Just started an almost 3 day print for my Majora’s Mask project.
Well, maybe I should have run some more test prints after greasing (and partly disassembling) my printer but I’m running out of time 😆
I guess running an internal check and calibration and crossing my fingers will have to be sufficiant.

#3dprinting #3dprinter #prusa #prusamk3s #3ddruck #3d_druck #3ddrucker #3d_drucker @3dprinting