Second, I was having really bad 2nd layers for no apparent reason... thinking it was me just hitting the max flow rate of the Revo 0.4 nozzle, I ordered a new Revo High Flow 0.4 which arrived this morning... my surprise was when I removed the old one and it was "blue", which means... 0.6! 🤦♂️
First, it took me a few prints until I realized there was a protective film on the smooth PEI side of the build plate that we are supposed to remove... 🤦♂️
If you've been following along this, I thought it is worth now to post some thoughts after configuration and calibration and a few prints! 🙂
And... it is is ready!! 🤩
Now starts the time to configure and calibrate everything!
First boot successful! 🙂
#Voron #LDOMotors #Fluidd #Klipper #3DPrinting #3DPrinter #BigTreeTech
Print bed is in place, wiring is now complete!
The wire loom is now connected to the toolhead and inside the drag chains!
Had to repin the Chaoticlab CNC Voron Tap cable, as the LDO Toolhead PCB has 24V-S-GND instead of S-GND-24V
#Voron #LDOMotors #Fluidd #Klipper #3DPrinting #3DPrinter #Chaoticlab #VoronTap
_FirstLayer 🇳🇱
Pedro Lamas