Mock up of what the Skiffy 442 would be like with the new linear PSU option. I still need to do some QC on checking for ripple and noise but the burn in test went well.

#Eurorack #EurorackPower #LinearPSU

Here's the PSU powering an actual module (our WaveBoy of course)! I tested it with a full 8 too!

#Eurorack #PowerSupply #EurorackPower #LinearPowerSupply

It didn't blow up! Initial test of my linear half-wave rectified Eurorack PSU seem good!

#Eurorack #EurorackPower #LinearPSU #Modular #ModularSynthesizer

Let's uh let's try that again :) I was
going through the BOM and realized, duh, I should
probably use the standard 2x8 IDC headers. Even
though all my own modules use +/- 12V and do not use
the CV/Gate pins, I would have to make custom cables
to fit my previous design. So I updated those and made
sure the CV, Gate, and 5V pins all connect as they
should (even though this board does not provide 5V). I
also added protection diodes, LEDs (to include power
to the +12V and -12V rails), and tantalum capacitors
since the datasheet of the regulators I'm using
suggests using them. I don't recall that being common
the last time I build a linear supply but may as well
follow the datasheet.

#TakeTwo #Eurorack #EurorackPower #EurorackDIY
#Modular #DIY