Mastodawn

Nul op de teller. OMD zong er al over.

https://janvandenberg.blog/the-final-source-of-energy/ #Domoticz #OMD #Solar

DomBus32: www.creasol.it/DomBus32 store.creasol.it/DomBus32
- 3 relays, 3 AC inputs, 5 low voltage inputs
- Home Assistant, Node-RED, Domoticz, Modbus, MQTT
- Very low power consumption: 15mW with relays OFF, 150mW with all relays On
#homeassistant #NodeRED #domoticz #ModbusRTU #relays #valves

Creasol - Smart Home solutions Feb 13

DomBus38, high quality domotic modules with inputs and relay outputs, working with #domoticz #homeassistant #nodered #Modbus #MQTT - Check our PDF catalog: https://creasol.it/catalog - Store: https://store.creasol.it

Creasol - Smart Home solutions Feb 4

Full PDF catalog at www.creasol.it/catalog
#domoticz #homeassistant #nodered #openhab #modbus #mqtt #domotica #homeautomation #catalog #products

Creasol - Smart Home solutions Feb 2

12 inputs, 3 AC inputs, 3 relay outputs
IoT module for #homeassistant #nodered #domoticz #mqtt #modbus www.creasol.it/DomBus37
High reliability, very low power consumption

Creasol - Smart Home solutions Dec 30

#homemade #solartracker 1.66kWp using DomBusTracker2 controller
www.creasol.it/DBT
#photovoltaic #domoticz #homeassistant #nodered #modbus

Creasol - Smart Home solutions Dec 17

https://www.creasol.it/EVSEHA
Energy dashboard on Domoticz (free home automation system) while charging my Kia car using DomBusEVSE home-made wallbox using DomBusEVSE module (working also with Home Assistant, NodeRED, ...): cost for 100km using electricity from grid and #photovoltaic
#domoticz #homemade #wallbox #kia #electriccar #evcharging

kaaswe Dec 13

After 15+ years of #Domiticz home automation software I figured it’s time to try Home Assistant, not really because I need it, more because I can.

My environment is quite large and complex so it’s going to be a long transition, bare with me

I’m using MQTT, a lot of Node-red logic, IKEA with gateway, a huge 1-wire network, several bash scripts, several Blocky scripts, Rfxcom with a lot of devices. Many scenarios and time events, ambient controls, and much more.

For now I have a Docker running HA and a ESPHome connected to the IKEA Gateway and realized that it can’t see the events from IR sensors and that I probably need a Zigbee gateway. Happy to get a nodeMCU showing the temp values from a DS18B20 Dallas on the GPIO pins but sadly realized that to configure each device it needs to be available as a pre built device. Hmmm and a lot of my devices are not yet integrated, this means I will need a 1-wire master for the HA, because I like to leave the Raspberry 1-wire setup as today. Why? Because I have to put too much work into it at every upgrade and the Rpi stability considering SD-cards are not the best. (Even though my last installation has run 4+ years on the same card)

Well, the slow journey has at least started towards a new environment, let’s see how it progresses

#1wire #domoticz #homeassistant #automation